The tio Rock C is the first dedicated brushed controller for Rock Crawling from Mtroniks. It has selectable battery type and an EXTREME 6V/5A BEC!
With the crawling section of RC continuing to grow, Mtroniks has added a new speed controller to its range .... the tio ROCK-C.
The Rock-C speed controller has been designed around an intelligent bridge switching processor, this allows far greater control of the motor in drive and braking modes, resulting in much better, perfect low speed control and fully symmetrical performance with no delay in forwards or reverse.
The Rock-C has a high power 5volt/ 5Amp BEC that’s perfect for super high-torque servos. It’s extreme power drag brakes provide monster holding power and are unbeatable for controlled downhill descents.
The Rock-C also includes, built in Li-Po cut off protection, this monitors the battery packs voltage, and prevents them from dropping below safe levels.
The Rock-C can be programmed to run on NiCAD/NiMH cells or Li-Po cells with one easy press of a button. Another feature of the Rock-C are its two different running modes. Crawler mode has monster drag brakes and a reduced throttle profile to give even finer control across the throttle range. The second mode gives full power throttle and standard brakes.
Add the already legendary 100% waterproof design and the Rock-C is definitely a serious contender for any crawling competition!
A break down of the tio Rock C specification can be seen below
|ESC Type:||For Brushed Motors|
|Max Nimh Volt Rating:||12v / 10 cell|
|Max Lipo Volt Rating:||11.1v / 3s|
|Battery Connector Type:||Tamiya Connector|